Linkr Bee Terminal

Checking Web Bluetooth…

Disconnected

Panel

Connection

New host: press the Bee pairing key once (Linkr Bee X1.0: USER_KEY/GPIO3; C3/C5: GPIO1), then connect within 30 s. Bonded hosts reconnect without a key press.

Device Diagnostics

Firmware –

Uptime –

BLE access –

UART Buffer –

WiFi –

Upload Queue –

BLE device name

Shown when scanning nearby devices. 1–29 UTF-8 bytes; Chinese and emoji are allowed (an emoji usually uses 4 bytes). The Device ID used for verification does not change.

Advertised name

Connect over BLE to read the current name.

已配对设备

Terminal Settings

UART

BLE UART mode

Enter key Chunk size

Terminal font Nerd Font options use fonts installed on this device.

Local echo Debug I/O

Log view

Reading hides only registered Agent wrappers and exit markers. Raw exports and board WebDAV retain original UART bytes.

Session Shell integration

Optional for an idle POSIX shell. Defines a temporary function without sudo or files; commands still run in sh subprocesses. Re-enable after reconnecting or starting a new chat. Disabling only changes future tracking.

WiFi & WebDAV

Network name Password

Scan to select a nearby 2.4 GHz network.

WebDAV

Status LED

Available on the Linkr Bee X1.0. Commands use the encrypted management channel, not the target UART.

–

Isolated contact (J5)

Pulse length (ms)

–

Infrared remote & learning

Send a NEC frame, or learn any remote's signal and keep it on the board.

Send NEC frame

Address Command Repeats

–

Learn a signal

Point a remote at the receiver and press a key; the frame is saved about 60 ms after the key is released.

Slot

–

Saved signals

Kept in the board's NVS, so they survive reboots. Play sends one directly.

Cheat Sheet

Linux Commands

Shortcuts

Tip: click a command to send it when connected.

AI configuration

AI provider API base URL API key

Model ID

Advanced options

Extra request headers API protocol Reasoning effort Context window in tokens (optional) Max output tokens (optional) Token prices per 1M (optional)

CLIProxyAPI server URL Temporary management key

On-board AI prompt

The custom instructions are stored in the board's NVS. The assistant reads them when a conversation starts, so they follow the board instead of one browser.

Custom instructions

0 / 240

–

About

An open-source serial terminal for Linkr Bee bridges, with an assistant that talks to the model service you configure.

Open source components

Everything the app and its firmware ship, with the licence each one is distributed under. The full licence texts travel with the components.

Licences and compliance

This project is released under Apache-2.0.
Third-party components remain the property of their authors and are distributed under their own licences, listed above.
DOMPurify is dual-licensed MPL-2.0 / Apache-2.0; this project uses it under Apache-2.0.
The macaron cursors are CC-BY-4.0, © UnionTech Software Technology Co., Ltd.; three shapes were converted from XCursor to PNG. Attribution and the source revision are in vendor/macaron-cursors/README.md.

Contributors

Taken from the git history of radxa/linkr-bee; duplicate identities are merged.

Repository Report a problem Licence text

Serial Terminal

xterm.js

No device yet

Tap Connect to scan for a nearby Linkr Bee

Connect a device to enable terminal input

0 RX 0 TX Baud 115200 Disconnected